+- RoboDK Forum (//m.sinclairbody.com/forum)
+-- Forum: RoboDK (EN) (//m.sinclairbody.com/forum/Forum-RoboDK-EN)
+ - - -论坛:一般问题tions about RoboDK (//m.sinclairbody.com/forum/Forum-General-questions-about-RoboDK)
+--- Thread: Curve follow project (/Thread-Curve-follow-project--3681)
Curve follow project-Tsvetkov-11-04-2020
Hello, I encountered a problem: I created a project, in it I created a trajectory whith tool orientation folowing option. Trajectoryneed to turn 6 axis more than 360 degrees. The robot runs along a curve and stops at the limit of +-360 degrees on the 6th axis. Is it possible to make so that the program has had to turn the 6th axis beforehand. Now the rotation starts at +26 degrees, reaches 360 and spins the axis. Is there any way to start follow curve from -334 degrees ?
RE: Curve follow project-Jeremy-11-04-2020
Hi Tsvetkov,
In your Curve Follow Project you have the option to "Prefered Joints for Starting points".
Jeremy
RE: Curve follow project-malibor-11-05-2020
I'm looking for option for tool to follow curve, but not to point on curve center. Meaning the tool isn't normal to the curve.Is it possible?I've tried to define TPC at the point I want it to follow, but it is still points to the curve center.
Thanks
Boris
RE: Curve follow project-Tsvetkov-11-05-2020
Thank you very much, it was very helpful.
RE: Curve follow project-Jeremy-11-05-2020
It's a pleasure Tsvetkov.
Boris, you should start a thread for your question.
A possibly add screenshots and your .rdk station.
Jeremy