+- RoboDK Forum (//m.sinclairbody.com/forum)
+--Forum: RoboDK (EN) (//m.sinclairbody.com/forum/Forum-RoboDK-EN)
+--- Forum: General questions about RoboDK (//m.sinclairbody.com/forum/Forum-General-questions-about-RoboDK)
+--- Thread: 3D printing-robot collision detected error (/Thread-3D-printing-robot-collision-detected-error)
3D printing-robot collision detected error-Mira-05-08-2020
Hi,
I am new to ROBODK and I just try to follow and practice the video on "3D printing with a robot". When I want to run the 3D printing simulation, the simulation doesn't run and it says the robot collision detected. How can I solve this issue?
Best regards,
RE: 3 d printing-robot碰撞检测到错误-Albert-05-12-2020
You should stop collision checking by selecting:
- Tools-Check collisions
More information here:
//m.sinclairbody.com/doc/en/Collision-Avoidance.html#GeneralCollisions
RE: 3 d printing-robot碰撞检测到错误-Mira-05-12-2020
(05-12-2020, 10:58 AM)Albert Wrote:You should stop collision checking by selecting:You can also define your collision map to narrow collision checking.
- Tools-Check collisions
More information here:
//m.sinclairbody.com/doc/en/Collision-Avoidance.html#GeneralCollisions
Thank you very much for the info.
I have another issue in this step. In the tutorial, after slicing the object and updating the 3D print parameter, bydefault, RoboDK create a programcalledExtruder. In my case I can run the simulation but there is no program events created. am I missing something?
RE: 3 d printing-robot碰撞检测到错误-Albert-05-12-2020
You should right click your program and select "Show Instructions".