RoboDK Forum
Slic3r settings problems- Printable Version

+- RoboDK Forum (//m.sinclairbody.com/forum)
+-- Forum: RoboDK (EN) (//m.sinclairbody.com/forum/Forum-RoboDK-EN)
+--- Forum: RoboDK bugs (//m.sinclairbody.com/forum/Forum-RoboDK-bugs)
+--- Thread: Slic3r settings problems (/Thread-Slic3r-settings-problems)



Slic3r settings problems-Daydriver-10-23-2019

Whenever I try and use the 3D printing module and I select a part for 3d printing I get an error message that says "Current 3D printing settings do not produce any result, Use appropriate 3D printing parameters for the selected part."

我试过在slic3r和许多不同的设置every time I get the same error message. Even when I use the supplied box for 3d printing it does not work. Any ideas where I could be going wrong.

The IRB120 3d printing demo does work though.

Running Slic3r 1.3.0 and RoboDK v4.0.0
Thanks

Well I think I figured it out. I think the object that was to be printed was using a reference frame that was not correct some how. I will see if I can re create the problem and post it.